AT&T Merlin Legend 10BS System Manager's Manual page 158

Troubleshooting
Hardware Verification
Master Controller Verification
When the Power-On Self Test (POST) is initiated on booting the system, two
columns of information appear on the screen. The left-hand column identifies the
item being tested; the right-hand column indicates PASS, FAIL, or the amount of
memory allocated.
If any item has FAIL in the right-hand column, report this information when
making a service call. If you are using a Master Controller II+ or Master
Controller III, you may be asked to check your configuration setup parameters as
described in Chapter 3 of the AT&T Applications Controller User Guide
(Document No. 585-249-710) or the AT&T Master Controller III User's Guide
(Document No. 560-407-150).
To fully diagnose any problems on a Master Controller II+ or Master Controller
III, use the Diagnostic Program provided with your processor. Consult the AT&T
Diagnostic Program User's Guide (Document No. 560-407-151) for
comprehensive instructions on how to use the program. If you have a Customer
Test disk provided with your system, use it to fully diagnose any problems. To
run the Customer Test diagnostics, follow these steps:
1. Insert the Customer Test disk supplied with the system into disk drive A.
2. Boot the system by turning power ON or if the system is on, do a
shutdown and press the
— The system boots from the Customer Test disk and displays the
3. Press
— The Customer Test main menu appears.
4. Select either System Checkout or Test All Modules by using the
DA
5. Press
6. Follow the directions on the screen to run the diagnostics.
7-2
Reset
Customer Test introduction screen.
to continue.
Enter
key.
NOTE:
If Test All Modules appears on the main menu, Customization
Screen will also appear. The interactive mode must be set to on
on the Customization Screen before selecting Test All Modules
for the speaker test, floppy disk drive test, keystrokes and typematic
tests, and mouse tests to be performed. If the interactive mode is
off these tests will not be performed.
.
Enter
button.