Table of Contents
Advertisement
3.4
Hull Unit Checks
Note 1: To avoid damage to the equipment, do not transmit while dry docked.
Note 2: When performing maintenance to the hull unit and checking the movement,
make sure that only the hull unit is powered and perform all checks in test mode to
avoid accident or injury.
Note 3: Make sure all connections to the hull unit are made correctly, referring to the
wiring table attached to the hull unit, to prevent the shaft from being dislodged.
How to check transmit status
Transmission is set to [OFF] as factory default. You can check and change the status
by doing the following.
1. Press the MENU/ESC key to open the menu.
2. Select [8 Test].
3. Select [9 Transmission].
4. Select the appropriate setting.
5. Select [Quit].
6. Press and hold the MENU/ESC key to close the menu.
How to check the hull unit
1. Press the power button to turn the power on, then check that the LEDs located to
the left of the power button and
Menu
Test
1 Operation Test
2 Board Test
3 Channel Test1
4 Channel Test2
5 Noise Measureing
6 Dummy Test
7 NMEA Monitor
8 Fan Monitor
9 Transmission
: OFF
0 Next
Quit
Cancel
OFF
ON
ON (No Charge)
ON (No Alarm)
(Retract) key are turned on.
3. ADJUSTMENTS
Quit
3-5
Advertisement
Table of Contents
