Table of Contents
Advertisement
3.
ADJUSTMENTS
3.1
DIP Switch Settings in the Processor Unit
When a monitor is connected via a video distributor or matrix switcher, the resolution
may not display correctly. If this occurs, change the DIP switch settings for SW4/SW5
on the PCRI board. The changed settings fix the output to SXGA.
Note: Only use the settings outlined in the following table.
1
2
DIP switch SW4 is used for setting the output resolution from HDMI1.
ON
ON
OFF OFF
DIP switch SW6 is used for setting the output resolution from HDMI2.
ON
ON
OFF OFF
3
4
5
6
OFF OFF OFF OFF OFF OFF
ON
ON
OFF OFF OFF OFF HDMI1 port outputs SXGA.
OFF OFF OFF OFF OFF OFF
ON
ON
OFF OFF OFF OFF HDMI2 port outputs SXGA.
7
8
HDMI1 port outputs at the maxi-
mum resolution of the monitor con-
nected to the processor unit
(factory default).
HDMI2 port outputs at the maxi-
mum resolution of the monitor con-
nected to the processor unit
(factory default).
Remarks
3-1
Advertisement
Table of Contents
