Table of Contents
Advertisement
5. Screw two mounting screws (supplied locally) into the upper fixing holes.
6. Fasten all screws tightly to secure the unit in place.
Mounting screw
(M10 bolt
1.8
Extension Box
Install the extension box to the hull unit when mounting the control box separately from
the hull unit. Remove the control box from the hull unit, then secure the extension box
to the position where the control box was secured. For how to remove the control box
from the hull unit, see section 1.7.
1. Set the extension box to the bolt on the rear (stern) side of the hull unit.
2. Secure the extension box to the hull unit, using four hex nuts, spring washers and
flat washers.
Note: Use the hex nuts, spring washers and flat washers that were used for se-
curing the control box.
Spring washer
Flat washer
Hex nut
1. MOUNTING
Detailed view
Set the notches of the unit to
the screws.
1-33
Advertisement
Table of Contents
