Table of Contents
Advertisement
1. MOUNTING
1.6
Matching Box
Install the matching box on the hull unit. The following two mounting directions are
available for the matching box.
• Matching box cover faces to the port side.
• Matching box cover faces to the stern direction. This mounting direction is same as
the control box.
Note: If the matching box is to be installed facing in the stern direction, change the
mounting base positions.
Matching box cover facing to port
1. Screw two mounting screws (M10, supplied) into the lower fixing holes on the hull
unit. Leave 5 mm of thread visible.
2. Set the notches of the unit onto the screws fastened at step 1.
3. Screw two mounting screws (M10, supplied) into the upper fixing holes.
4. Fasten all screws tightly to secure the unit in place.
Mounting screw
(M10 bolt
Matching box cover facing to stern
1. Unfasten the four upset screws (M5×12) to remove the two mounting bases from
the bottom of the unit.
1-30
Upset screw
(M5×12, 4 pcs)
Mounting base
Detailed view
Set the notches of the unit to
the screws.
Advertisement
Table of Contents
