Table of Contents
Advertisement
BEFORE YOU BEGIN
headline
Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents, or kinked cables that may have occurred during
shipping. Because the electric scooter was partially assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER BUTTON IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult with experience in bicycle mechanics.
Allow up to 30 minutes for assembly, not including initial charge time.
Allow up to 6 hours for charge (see page 7 for charging information).
Charger
Note: Charger design may
vary from one shown
Throttle
Headlight
Front Fork
Required Tools
5 mm Allen Wrench
(included)
3.
Front Seat
Brake Lever
T-tube
1.
Collar Clamp
Quick Release Lever
Seat Post
2.
8/10 mm Wrench (included)
and Two (2) 13/15 mm
Wrenches (included)
Tail/Brake Light
Passenger Seat
Passenger Foot Pegs
(Left/Right)
Center Stand
Phillips Screwdriver (not included)
3
3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR ELECTRIC SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void
the warranty.
Product ID Locations:
(See locations to the left)
1. Bottom of T-tube
2. Side of Battery Box
3. Charger
4. UPC Side of Box (Not Shown)
Box Contents:
• Electric Scooter
• Charger
• Owner's Manual
• Tools
• Basket
Advertisement
Table of Contents
