To Place A Call To A Member Of Your Workgroup; To Pick Up A Ringing Call To A Member Of Your Workgroup; To Transfer A Call To A Member Of Your Workgroup; To Pickup A Held Call From A Member Of Your Workgroup - NEC DT820 Series User Manual

To p l ace a cal l to a membe r of your wor kg ro u p
•
To p i ck u p a ri n g i ng c all to a member of yo u r wo rkgr oup
•
To tr ansfer a cal l t o a member o f your w o rkg ro u p
•
To p i cku p a hel d call f r om a member of yo u r wo rk gro up
•
DT700 Phone User Guide
D T 8 2 0 C O L O R M I C R O B R O W S E R A N D E N H A N C E D P R O G R A M M A B L E K E Y S
• Transfer: Transfer allows the phone user to perform a transfer of the connected call
or held call that is in focus to the Subscribed Address. A Transfer operation on a
non-connected call or held call that is not in focus has no operation.
• Call Back: Call Back functionality allows the phone user to set call back on a
Subscribed Address. When that address becomes idle, the phone notifies the user
by providing visual and audible indications through the key LED and by playing a
soft ring. On receiving the notification, the user can place a call to the Subscribed
Address either by pressing the Call soft key or by dialing the address using the
keypad.
S I N G L E P R E S S B E H A V I O R
You can use a programmed key to directly place calls to other workgroup members.
While your phone and the other workgroup member's phone is idle, do one of the
following:
• To make a hands-free or headset call: Press the key for the workgroup
member you want to call, then use your headset or the phone's speaker to
continue the call on your phone.
• To use your phone handset for the call: Pick up your phone handset, then
press the key for the workgroup member to continue the call on your phone.
If you are set up for a workgroup, you will see a flashing green LED when there is a
ringing call on any other workgroup member's phone.
While your phone is idle and the other workgroup member's phone is ringing, do one of
the following:
• To place a hands-free or headset call: Press the key for the workgroup
member, then use your headset or the phone's speaker to continue the call on
your phone.
• To use your phone handset for the call: Pick up your phone handset, then
press the key for the workgroup member to pick up the call.
While you are connected to a call, press the key for the workgroup member to transfer
your call to that workgroup member.
Your current call is placed on hold, and the phone attempts the transfer.
If you have multiple calls on hold, the phone will transfer the call that is currently in
focus.
The default type of transfer (blind or consult) for this key is controlled by your
Note:
system administrator.
When another user has a call on hold, you will see a red flashing LED for that user.
While your phone is idle and the other workgroup member's phone has a held call, do
one of the following:
Enhanced Programmable Keys
9 -141