Eizo DuraVision FDF4627W-IP Installation Manual page 52

Stream Profile
*5
Media Profile
Transmission Mode
*7
URI
Comm. Method
*1 If the "Protocol" is set to "DirectUri" and if the "URI" starts with rtp://, 1824 to 65534.
*2 Enter the username with administrator rights and the password. Configure as necessary if the "Protocol"
is set to "DirectUri".
*3 Compatible only if the "Protocol" is set to "Panasonic".
*4 Compatible only if the "Protocol" is set to "AXIS".
*5 Compatible only if the "Protocol" is set to "ONVIF".
*6 Compatible only if the "Protocol" is set to "AXIS" and "ONVIF".
*7 Compatible only if the "Protocol" is set to "DirectUri".
*8 Possible to set only "RTP over UDP" in the following cases.
• In the case where "Protocol" is set to "Panasonic".
• In the case where "Protocol" is set to AXIS" and "Transmission Mode" is set to "Multicast".
• In the case where "Protocol" is set to "ONVIF" and "Transmission Mode" is set to "Multicast".
• In the case where "Protocol" is set to "DirectUri" and "URI" starts with rtp://
4. Set the changes, and select "OK".
Returns to the camera registration information list screen in step 1.
5. Select "Apply".
A setting confirmation dialog box appears.
6. Select "OK".
Note
• The following message is displayed when the system fails to acquire the "Obtain Camera Name" and "Obtain
Profile" information. Obtain the information again.
52
Chapter 3 Configuring from a Web Browser
*4
Select the profile that the network camera has.
When "Obtain Profile" is selected, the profile is
automatically selected from the network camera.
Select the ONVIF image profile. When "Obtain
Profile" is selected, the profile is automatically
selected from the network camera.
*6
Select the transmission mode for camera images.
Set the URI that starts with rtsp:// or rtp://.
Select the Comm. Method for camera images.
According to the camera
specification
EIZO_Profile / camera profile
Unicast / Multicast
Alphanumeric
(up to 255 characters)
*8
RTP over UDP /
RTP over RTSP