Eizo DuraVision FDF4627W-IP Installation Manual page 22

Preset
Preset the shooting position and adjustment status of the network camera.
1. Select the number (1 to 256) to set for "Preset No".
2. Configure the items.
Item
Brightness
Focus
Zoom
Position
3. Select "Register (Home)" for registering the selected number as the home position. For all other
registrations, select "Register".
The registration completion screen is displayed. Select "OK".
Attention
• It is not possible to configure the network camera when its "Protocol" is set to "AXIS" or "DirectUri". Set the
preset settings on the camera side.
• Depending on the type of the network camera you are using, some functions may not be available.
• Depending on the network camera type, it may not be possible to register the brightness and focus settings.
Note
• After the setting is registered, the number displayed at "Preset No." changes from "Not Registered" to "Home"
or "Registered".
• To clear a setting, select the number to clear at "Preset No." and then select "Delete". The data set for the
number is deleted and the number status returns to the unregistered state.
22
Chapter 2 Configuring from the monitor screen
Displays images of the selected network camera.
1
2
3
Detail
Adjust the network camera brightness.
Adjust the network camera focus.
Adjust the network camera display
magnification.
Adjust the network camera shooting
position (pan / tilt).
Setting range
According to the camera specification
According to the camera specification
According to the camera specification
According to the camera specification