Changing The Cpm2B's Mode With The Mode Switch - Omron SYSMAC CPM2B Operation Manual

Using a Programming Console
Contrast Control
Buzzer Volume
7-1-2

Changing the CPM2B's Mode with the Mode Switch

122
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The display contrast can be adjusted with the control on the right side of the
Programming Console.
The C200H-PRO27-E's buzzer volume can be adjusted with the lever on the
right side of the Programming Console. The CQM1-PRO01-E's buzzer vol-
ume cannot be adjusted.
Note The buzzer volume can be turned on and off with a key operation. See 7-2-6
Buzzer Operation for details.
Once the Programming Console has been connected, its mode switch can be
used to change the CPM2B's operating mode. The mode display (<PRO-
GRAM>, <MONITOR>, or <RUN>) will appear on the Programming Console
screen.
• No key operations can be performed while the mode display is displayed
on the Programming Console screen. Press CLR to clear the display so
that key operations can be performed.
• If the SHIFT Key is pressed while the mode switch is turned, the original
display will remain on the Programming Console's screen and the mode
display won't appear.
Contrast control
C200H-PRO27-E
Section 7-1
Low volume
High volume