Operation - Omron V600-CA8A-V Series Operation Manual

Operation

1-3 Operation
R/W Head 1
(Machining command
data read)
Pallet
1, 2, 3...
4
ID Controller
Programmable
Controller
(PC)
Machining/inspection
1. When a command is sent from the host computer to the ID Controller, R/W
Head 1 enters the waiting condition and waits for the arrival of the DC. The
command data at this time specifies the memory area from which data is to
be read by R/W Head 1.
2. When the DC arrives within communications range of R/W Head 1, the data
(format and machining/inspection command data) in the memory area indi-
cated by the read command is sent to the host computer as the response.
3. Based on the response data, the host computer transmits the workpiece
machining/inspection command to the PC.
4. Once operations in the machining/inspection process have been com-
pleted, a write command is sent to the ID Controller, and this time R/W Head
2 waits for arrival of the DC. This command sets the memory area to which
R/W Head 2 is to write data and set the machining/inspection results data.
5. When the DC arrives in the R/W Head 2 communications range, the machin-
ing/inspection results data is written to the memory area specified by the
DC.
R/W Head 2
(Write inspection
results data)
To next
process
Pallet
Section 1-3
All V600-series
Read/Write Heads
and Cata Carriers
can all be connected.