Monitor Unit Operation List; Basic Operations - Omron V600-CA8A-V Series Operation Manual

Monitor Unit Operation List

DATA Setting
4-2

Monitor Unit Operation List

4-2-1 Basic Operations

Operation Description
mode
Changing Switches ID Controller
operation mode operation mode
Job Specifies Head and
specification page numbers required
for given operations
Numerical keys Used for setting
address, specifying
data, and selecting
functions
Address setting Sets the address from
which data is read or to
which data is written in
the range 00 to FF.
Data Specifies the 8-bit data
specification (00 to FF) to be written
to the DC.
For a write operation, one byte of the specified data is written to the DC in the
area defined by the start and end addresses.
Note 1. Data setting is not required for an operation test with the test read or test
auto read command to check the relationship of the position.
2. If the DC's memory capacity is more than 256 bytes, data cannot be written
to address 00 or 01 when page 0 is set with a page number because these
addresses are used to register the production month and year of the DC.
Nothing can be written to addresses 0002 to 0005 because these addresses
are used as a write protected area.
If the DC's memory capacity is 256 bytes or less, no data can be written to
or
address 00 when page 0 is set with a page number because this address is
used as a write protected area.
MONITOR Mode
JOB
Start address
ADRS
End address
Note Monitor Unit read and write data is limited to HEX code.
Basic operation procedure
RUN Mode
or
MONITOR
RUN
INC SET INC
Head no. setting Page no. setting
Address and data specifications
to
o F o
Upper digit Lower digit
Function selection
to
1 4
to to
o F o
Upper digit Lower digit
to
o F
ADRS
Upper digit
to
o F o
DATA
Upper digit Lower digit
Section
RUN
INC SET
to
F
F
to
o F
Lower digit
to
F
4-2
Page
43
44
---
45
46
41