Emerson Rosemount OCX 8800 Reference Manual page 234

Maintenance and service
7.
8.
Remove eductor
Complete the following steps to remove the eductor from the OCX 8800.
224
Figure 9-9: Alignment of COe sensor assembly
A. Matchmark
B. Straightedge
C. Sensor holder flat
With one wrench holding the eductor elbow (N,
of sensor holder (J), unthread and remove the COe sensor assembly (I). Do not allow
the eductor elbow to turn.
Slide the band heater (M) and heater insulator (K) from the sensor holder (J).
Figure 9-8) and one wrench on flats
OCX 8800