Emerson Rosemount OCX 8800 Reference Manual page 135

Table 7-9:
Operating mode description
ALARM
SYS FAULT
CAL RECOMMENDED
Table 7-10:
SENSOR_HOUSING_TYPE description
TYPE 1
TYPE 2
TYPE 3
Table 7-11:
CAL_RESULTS description
O slope error
2
O constant error
2
O tolerance check failed
2
CO slope error
O constant error
2
CO tolerance check failed
CO slope warning
During a running calibration verify procedure, the states below reflect the current step
that the calibration verify is running in.
Table 7-12:
VERIFY_STATE description
Idle
Flow high O
Flow low O
Flow high COe gas
Purge gas
Done
During a calibration, the VERIFY_STATE_STEP command/parameters control the
calibration verify procedure.
Reference Manual
Operating mode enumerations
Sensor housing enumerations
Cal results bit enumerations
Calibration verify state values
gas
2
gas
2
(continued)
Foundation Fieldbus
125