Removing A Module; Figure 21 Loosening Screws On The Module: Passport 8003, 8006 - Nortel Passport 8600 Series Manual

46 Chapter 2 Installing Passport 8600 modules and connecting equipment

Removing a module

You can remove any Passport 8600 module from an operating switch chassis
without turning off the chassis power.
To remove a module:
1
Disconnect any cables attached to the ports on the module.
2
Using a Phillips screwdriver, loosen the 2 captive screws that secure the
module to the chassis
Figure 21 Loosening screws on the module: Passport 8003, 8006, and 8010
312749-B Rev 00
Caution: Before you remove a Passport 8691SF Module, back up your
configuration. If the chassis has only one Passport 8691SF Module and
you remove that module, the switch will not operate.
Caution: Do not operate the Passport 8600 Switch with an empty
module slot. If you need to replace a failed module and you do not yet
have a replacement module, leave the failed module installed or install a
filler panel.
(Figure 21
Chassis
or Figure 22).
10355FA