Table of Contents
Advertisement
Chapter 6
USB Port
t
Avaya
Line Interactive RM UPS Site Preparation, Installation and Operator's Manual
Communication
The Avaya Line Interactive RM has flexible communication options for
local, network, or remote monitoring and management. You can use the
USB port or the DB-9 communication port to connect your computer to
the UPS. The X-Slot communication bay is also available for additional
connectivity options.
NOTE Select only one method for communication. If an X-Slot card is installed, the USB
and DB-9 ports are disabled. If an X-Slot card is not installed, be sure that only one port (USB
or DB-9) is connected to the computer.
The UPS can communicate with a USB-compliant computer using
Powerware
LanSafe
Power Management Software (v5.0.1 or higher).
®
®
To establish communication between the UPS and a computer:
1.
Connect the USB cable to the USB port on the UPS rear panel.
Connect the other end of the USB cable to the USB port on your
computer.
USB Port
2.
Install the Powerware LanSafe software and USB drivers according
to the instructions provided with the Software Suite CD.
Figure 22. The USB Port
S
164201663 Rev 1
43
Advertisement
Table of Contents
