Chapter 5
Voltage Configuration
t
Avaya
Line Interactive RM UPS Site Preparation, Installation and Operator's Manual
Additional UPS Features
This section describes:
S
Changing the voltage configuration
S
Network transient protector
S
Load segments
The DIP switches on the UPS rear panel (see Figure 18) are used to
configure the output voltage and the input voltage range.
1.
Verify that the UPS is off and unplugged.
To turn off the UPS, press and hold the
and then unplug the UPS from the power outlet.
2.
Set the DIP switches according to the configurations in Table 1.
3.
Plug the UPS into a power outlet.
4.
To turn the UPS on, press and hold the
UPS beep (approximately two seconds).
UPS Rear Panel
button for two seconds
button until you hear the
ON
1
2
Figure 18. DIP Switches
S
164201663 Rev 1
OFF
39