UPS Front Panel
The UPS front panel indicates the UPS status and also identifies
potential power problems. Figure 17 shows the UPS front panel
indicators and controls.
Load Segment 2 Indicator (green)
If the alarm beeps or a UPS alarm indicator stays on, see Table 9 on
page 56 to identify and correct the problem.
Initiating the Self-Test
NOTE The batteries must be fully charged and the UPS must not be in Battery mode to
perform the self-test.
Press and hold the
If the alarm beeps or a UPS alarm indicator stays on, see Table 9 on
page 56.
t
Avaya
Line Interactive RM UPS Site Preparation, Installation and Operator's Manual
Service Indicator (red)
Load Segment 1 Indicator (yellow)
On Battery Indicator (yellow)
Figure 17. UPS Front Panel
button for three seconds to initiate the self-test.
OPERATION
Power On Indicator (green)
On/Off Button
Test/Alarm Reset Button
Overload Indicator (red)
S
164201663 Rev 1
37