Installing The Ups - Avaya PW5115 500 RM Site Preparation, Installation And Operator's Manual

Installing the UPS

See Figure 15 and Figure 16 for the UPS rear panels.
To install the UPS:
1.
2.
NOTE If you need to change the factory-set defaults for the output voltage or input voltage
range, see "Voltage Configuration" on page 39 before installing the UPS.
3.
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
4.
X-Slot
Communication Bay
6-ft Power Cord with
5-15 Plug
t
Avaya Line Interactive RM UPS Site Preparation, Installation and Operator's Manual
If you did not mount the UPS in a rack or to a wall, place the UPS in
a flat, horizontal position.
If you are installing power management software, connect your
computer to the USB port or UPS communication port using the
supplied cable (see page 43).
Plug the equipment to be protected into the UPS output
receptacles (see page 41 for more information on load segments).
For 230V models only. Plug the detachable power cord into the input
connector on the UPS rear panel.
Network Transient
Protector
USB Port DIP Switches
Site Wiring Fault
Communication
Indicator
Port
Figure 15. 500–1500 VA, 120V Rear Panel
INSTALLATION
Four 5-15 Receptacles
S
164201663 Rev 1
33