Agilent Technologies 54830 Series Service Manual page 19

Chapter 1: General Information
Specifications & characteristics
*2
dc Gain Accuracy
2
Offset Accuracy*
dc Voltage Measurement
2,3
Accuracy*
Bandwidth Limit Filter
AutoProbe Interface
Horizontal
Main Time Base Range
Horizontal Position Range
Delayed Sweep Range
Resolution
Timebase Accuracy
Jitter, rms
Analog Trigger
2
Sensitivity*
Level Range
Sweep Modes
Trigger Coupling
Trigger Holdoff Range
Trigger Modes
1–10
± 1.25% of full scale at full-resolution channel scale. The dc gain accuracy
decreases 0.08% of full scale per degree C from the firmware calibration
temperature.
± (1.25% of channel offset + 2% of full scale) at full-resolution channel scale.
Dual Markers
Single Marker
20 MHz
AutoProbe is an intelligent communication and power link between compatible
probes and Infiniium scopes. AutoProbe completely configures the oscilloscope for
the attached probe. For instance, it identifies the probe type and sets up the proper
input impedance, attenuation ratio, probe power and offset range, as needed.
54830/31B/D
54832B/D & 54833A/D
0 to ±200s
1 ps/div to current main time base setting.
4 ps
15 ppm (±0.0015%)
8 ps ±0.05ppm x [Delay Time]
Internal (normal)
For vertical ranges >5 mV/div
External (54830B/D & 54833A/D)
Auxiliary (54831/32B/D)
Internal
External (54830B/D & 54833A/D)
Auxiliary (54831/32B/D)
Auto, triggered, single
dc, ac, low frequency reject (50 kHz), high frequency reject (50 kHz).
50 ns to 10 s
Edge
Line
Glitch
Pattern
±[(dc gain accuracy)+(resolution)]
±[(dc gain accuracy)
+(offset accuracy)+(resolution/2)]
500 ps/div to 20 s/div
200 ps/div to 20 s/div
dc to 500 MHz: 0.6 div
500 MHz to 1 GHz (50 Ω) 1.5 div
dc to 100 MHz: 0.05x(signal range)
100 MHz to 500 MHz : 0.10x(signal range)
dc to 500 MHz: 300 mV
pp
1 MΩ ±8 div from center screen
50 Ω ±8div from center screen
1 MΩ ±1 V, ±5 V, and ±25 V
50 Ω ±1 V, ±5 V, and ±8 V
±5 V
Select positive or negative polarity,
width. Triggers on glitches as narrow as
500 ps.
Select inputs as High, Low or X (don't
care) to create pattern. Triggers on
patterns as narrow as 2.5 ns.
Trigger when pattern is entered, exited,
present > t, present over a range of time.