Chapter 6: Replacing Assemblies
To remove and replace the AutoProbe assembly
b Locate the access hole in the front-panel assembly below and almost between channel
c From the back of the front panel, use a small screw driver or other slender pointed object
Figure 6-9
Access Hole
CA UT IO N
AVOID DAMAGE TO THE RIBBON CABLE AND FACEPLATE!
Do not pry around the edge of the assembly. Doing so may damage the ribbon cable or faceplate.
d Finish removing the AutoProbe assembly by feeding the mylar ribbon cable through the
Figure 6-10
Pushing Out the AutoProbe Faceplate
To replace the AutoProbe assembly, reverse the above procedure.
3
6–12
two and channel three attenuators.
through the access hole to push the AutoProbe assembly faceplate away from the front
panel assembly.
front panel slot.