Agilent Technologies 54830 Series Service Manual page 127

Chapter 6: Replacing Assemblies
To remove and replace the front panel assembly
Remove the four Torx T20 screws that secure the chassis sides to the front panel
8
assembly.
Figure 6-17
T20 Torx
Screws
Front Panel Side Screws
Remove the two Torx T10 screws that secure the chassis front to the front panel
9
assembly.
Pull the front panel assembly away from the chassis, being careful to feed the ribbon
10
cables W11 and W12 out through the slot in the front of the chassis and not to damage
the backlight inverter board.
To replace the front panel assembly, reverse the above procedure.
11
Ensure that you observe polarity designations when reconnecting the ribbon cables.
6–18
T10 Torx
Screws
T20 Torx
Screws