Agilent Technologies 54830 Series Service Manual page 129

Chapter 6: Replacing Assemblies
To remove and replace the keyboard and flat-panel display assemblies
To remove the cursor keyboard and flat lens, remove the four Torx T10 screws that
7
secure the lens corners, then carefully remove the lens. You can lift the cursor keyboard
directly out of the front casting.
Figure 6-19
Keyboard interconnect
Removing the Cursor Keyboard
To remove the backlights, lift the tab and slide each backlight out of the flat-panel
8
display.
Figure 6-20
Display
Removing the backlights
6–20