Agilent Technologies 54830 Series Service Manual page 106

BIOS Setup Procedure
Go to Load Setting 2 Defaults and press Enter key. Select Y to load the defaults of
1
BIOS Setting 2 and press the Enter key.
If you have a power board part number 54855-66502 then perform the following steps.
2
Otherwise, go to step 7.
Go to Power Management Setup and press the Enter key.
3
Select the PWORN After PWR-Fail setting and press the Enter key.
4
Select the Off option and press the Enter key.
5
Return to the CMOS Setup Utility by pressing the Esc key.
6
Press F10 to save and exit the setup. Type "Y" to save changes.
7
To Configure the motherboard jumpers and setup BIOS
Chapter 5: Troubleshooting
5–21