Table of Contents
Advertisement
Notes
• Do not modify the terminal or its accessories.
- Doing so may cause fire, injury or damage.
- The modified terminal may be repaired only if the owner agrees on that
all the modified parts are restored to the original conditions. However,
repairs may be refused depending on the modifications.
The following cases may be regarded as modifications.
› A sticker etc. is put on the display or key part
› The terminal is embellished with adhesive material etc.
› Exteriors are replaced with other than DOCOMO's genuine parts
- Repair of failures or damage caused by modification is charged even
during the warranty period.
• Function settings and information may be cleared (reset) by
malfunctions, repair or other handling of the terminal. Should that
happen, set up the functions again. Depending on the setting, a packet
communication charge may be applied. A packet communication fee may
be charged due to the settings.
• When the repair is executed, MAC address of Wi-Fi/Bluetooth address in
the terminal may be changed regardless of repaired part.
• Do not allow cash cards or other devices that are vulnerable to
magnetism to come into contact with the terminal.
• The terminal is waterproof. If inside of the terminal gets wet or moist,
immediately turn the power off, bring the terminal to a repair office as
soon as possible. However, repair may not be possible depending on the
condition of terminal.
Precautions on data created by you and downloaded data
Note that data you created, retrieved or downloaded from sources other
than your terminal may be changed or lost when you change the model
or have repairs done to the terminal. DOCOMO shall have no liability for
any change or loss of any kind. Please understand beforehand that you
can not be compensated by DOCOMO for packet communication charges
generated by re-downloading data. Under some circumstances, DOCOMO
may replace your terminal with its equivalent instead of repairing it. When
replacing your phone, most of the above-mentioned data cannot be
transferred to the new phone.
Updating software
Software update
Download update file for the terminal from the download site on the
Internet and update the software. For software update, there are 2
methods; connecting to the network directly on the terminal and using
Galaxy Smart Switch PC (P.133) installed to a PC.
Precautions on software update
Software update can be done with the data saved to the terminal
remained. However, note that depending on your terminal condition
(malfunction, damage, water-soaked, etc.), the data may not be protected.
You are recommended to back up the user information and data in the
terminal just in case. However, some data may not be backed up.
• Prepare the followings before software update.
- Exit all programs running on the terminal (P.45)
- Charge the terminal (P.26) to make the battery level enough.
• For updating software by connecting the terminal to network directly,
you are recommended to perform in a place with good signal condition,
without moving. When the signal condition is bad, software update
maybe interrupted.
• It may take time to update software (download and installation of update
files).
• During the installation of the update files for software update, all
functions including making/receiving phone call are not available.
• To update the software while you are overseas, connect to Wi-Fi network
(with the DOCOMO nano UIM card removed).
• When you cannot perform any operations because of the failure of the
software update, please take your terminal to DOCOMO-specified repair
office.
147
Appendix/Index
Advertisement
Table of Contents
