Configuring A Nonseed Member; Configuring User Authentication - 3Com 3CRWX120695A Installation And Basic Configuration Manual

76 C 3: C
HAPTER ONFIGURING A
Configuring a
Nonseed Member
Configuring User
Authentication
WX S B
WITCH FOR ASIC
To verify the change, use the following command:
display mobility-domain
The following commands configure a WX switch to be the Mobility
Domain seed, add two nonseed members to the member list, and verify
the change:
WX1200# set mobility-domain mode seed domain-name corp
success: change accepted.
WX1200# set mobility-domain member 10.10.40.4
success: change accepted.
WX1200# set mobility-domain member 10.10.50.4
success: change accepted.
WX1200# display mobility-domain
Mobility Domain name:
Member
---------------
10.10.10.4
10.10.40.4
10.10.50.4
To configure the current WX switch to be a member of a Mobility Domain
but not the seed for the domain, use the following command:
set mobility-domain mode member seed-ip ip-addr
Enter the system IP address of the seed switch.
MSS provides the following types of authentication:
IEEE 802.1X—If the network user's network interface card (NIC)
supports 802.1X, MSS checks for an 802.1X authentication rule that
matches the username (and SSID, if wireless access is requested), and
that uses the Extensible Authentication Protocol (EAP) requested by
the NIC. If a matching rule is found, MSS uses the requested EAP to
check the RADIUS server group or local database for the username
and password entered by the user. If matching information is found,
MSS grants access to the user.
MAC—If the username does not match an 802.1X authentication
rule, but the MAC address of the user's NIC or Voice-over-IP (VoIP)
phone and the SSID (if wireless) do match a MAC authentication rule,
S
ERVICE
corp
State
-------------
STATE_UP
STATE_UP
STATE_UP
Status
--------------
SEED
MEMBER
MEMBER