Configuring The Time And Date - 3Com 3CRWX120695A Installation And Basic Configuration Manual

40 C 3: C
HAPTER ONFIGURING A
WX4400# set license WXL-076E-93E9-62DA-54D8 WXA-3E04-4CC2-430D-B508
Serial Number
License Number
License Key
Activation key
Feature
Expires
48 ports are enabled
success: license was installed
Configuring the
Time and Date
WX S B
WITCH FOR ASIC
additional 24 MAPs, up to 96 MAPs total. You can upgrade the WX4400
only. The WX1200 cannot be upgraded.
To display the current license level and install an upgrade license, use the
following commands:
display license
set license license-key activation-key
The license key is shipped with the switch. To obtain the activation key,
access the 3Com web site. Each license and activation key pair allows the
switch to actively manage an additional 24 MAPs. You can install up to
three upgrade license and activation key pairs, to actively manage up to
96 MAPs.
The following command installs an upgrade license:
: M8XE4IBB8DB10
: 245
: WXL-076E-93E9-62DA-54D8
: WXA-3E04-4CC2-430D-B508
: 24 additional ports
: Never
The additional ports refers to the number of additional MAPs the
WX4400 can boot and actively manage.
To set the system time and date:
1 Set the time zone to specify the offset from Coordinated Universal Time
(UTC).
2 Configure MSS to offset the time by an additional hour for daylight
savings time or similar summertime period, if applicable.
3 Specify the IP address of a Network Time Protocol (NTP) server or statically
set the time and date.
S
ERVICE