Configuring Ip Connectivity; Configuring Vlans And Ip Addresses - 3Com 3CRWX120695A Installation And Basic Configuration Manual

42 C 3: C
HAPTER ONFIGURING A
Configuring IP
Connectivity
Configuring VLANs
and IP Addresses
WX S B
WITCH FOR ASIC
WX1200# display timezone
Timezone is set to 'PST', offset from UTC is -8:0 hours.
WX1200# display summertime
Summertime is enabled, and set to 'PDT'.
Start : Sun Apr 04 2004, 02:00:00
End : Sun Oct 31 2004, 02:00:00
Offset : 60 minutes
Recurring : yes, starting at 2:00 am of first Sunday of
April and ending at 2:00 am on last Sunday of October.
WX1200# display ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server
---------------------------------------------------
192.168.1.5
WX1200# display timedate
Fri Feb 06 2004, 12:03:04 PST
To configure IP connectivity:
1 Configure a VLAN, assign a port to the VLAN that can provide IP
connectivity through the network for administrative purposes, and
configure an IP address on the VLAN. (See "Configuring VLANs and IP
Addresses" on page 42.)
2 Configure a default route. (See "Configuring a Default Route" on
page 44.)
3 Test the IP configuration. (See "Verifying IP Connectivity" on page 45.)
Any or all VLANs on the switch can have an IP address. 3WXM and Web
Manager require IP connectivity to a WX switch to manage the switch.
User traffic also requires VLANs, although you do not need to configure
every user's VLAN on every WX switch. To configure a VLAN and an IP
address, use the following commands:
set vlan vlan-num name name
set vlan vlan-id port port-list [tag tag-value]
set interface vlan-id ip {ip-addr mask | ip-addr/mask-length}
S
ERVICE
Peer state
SYSPEER
Local State
SYNCED