Management Features; Power Features; Network Interfaces - 3Com 3CRWX120695A Installation And Basic Configuration Manual

Power
supply LED
100-240V
50/60 Hz
8A MAX
DISCONNECT
ALL POWER
BEFORE
SERVICING
AC power
inlet
Management
Features

Power Features

Network Interfaces

Figure 2 WX4400 Switch—Front Panel Control Features
Power
supply
Power supply GBIC slot
serial number
Like the WX1200, the rear of the WX4400 contains a label with the serial
ID, MAC address, and other identifying information.
Serial console port—The serial console port provides a direct
management connection to a WX switch's command-line interface
(CLI). The port has a DB-9 female connector and supports the
EIA-232D signaling standard.
Status LEDs—The Ethernet ports and power supplies have LEDs that
indicate their status. The management CPU on a WX4400 switch also
has an LED. (For details, see "Status LEDs" on page 14.)
Flash card slot (WX4400 only)—The flash card slot is not used for
normal WX operation.
Power supplies—A WX4400 switch comes with one 100-240 VAC
autosensing AC power supply. You can add a second supply for load
sharing and redundancy. The power supplies are hot-swappable.
A WX1200 switch contains one 100-120 VAC / 200-240 VAC
autosensing AC power supply. The WX1200 power supply is a
fixed-configuration supply and cannot be inserted or removed.
10/100 Ethernet ports—A WX1200 switch has eight 10/100BASE-TX
Ethernet ports. Each port has a standard RJ-45 connector and uses
Category 5 (Cat 5) cable based on the EIA/TIA-586 standard.
Serial Flash
console port card slot
Mgmt
Console
Gigabit
link
LEDs
Hardware Features
Eject Mgmt
button LED
1000BASE-TX port
13