Installing An Upgrade License - 3Com 3CRWX120695A Installation And Basic Configuration Manual

Installing an
Upgrade License
To configure an enable password:
1 If you are not already at the enabled access level, enter the enable
command.
WX1200> enable
2 At the enabled prompt, enter set enablepass.
WX1200# set enablepass
3 When you are prompted for your old password, press Enter.
Enter old password:
4 When you are prompted for a new password, enter an enable password
of up to 32 alphanumeric characters, with no spaces.
Enter new password:
The password you enter is not displayed.
5 When you are prompted to retype your password, reenter the enable
password.
Retype new password:
MSS does not display your password, but lets you know that the enable
password is set:
success: password changed
(For information about additional ways to secure CLI access, see the
Wireless LAN Switch and Controller Configuration
Table 10 lists how many MAPs you can configure on a WX switch, and
how many MAPs a switch can boot. The numbers are for directly
connected and Distributed MAPs combined.
Table 10 Maximum MAPs Supported Per Switch
WX Switch Model
WX4400
WX1200
You can install one or more upgrade licences to increase the number of
MAPs a WX4400 can boot. Each upgrade license adds support for an
Maximum
Configured Maximum Booted
256 24, 48, 72, or 96,
depending on the
license.
30 12

Installing an Upgrade License

Guide.)
39