Specifying The Country Of Operation - 3Com 3CRWX120695A Installation And Basic Configuration Manual

56 C 3: C
HAPTER ONFIGURING A
Specifying the
Country of
Operation
WX S B
WITCH FOR ASIC
Web Manager uses Hypertext Transfer Protocol over Secure Sockets Layer
(HTTPS), which requires TLS. Make sure TLS 1.0 is enabled on the Web
browser. For example, if you are using the Microsoft Internet Explorer:
1 Select Tools > Internet Options to display the Internet Options dialog
box.
2 Select the Advanced tab.
3 Scroll to the bottom of the list of options and select the TLS 1.0 option to
enable it.
4 Click OK.
To log in to a WX switch with Web Manager:
1 Type https://ip-addr in the Web browser's Address or Location field and
press Enter.
For ip-addr, type an IP address you configured on the switch. (See
"Configuring VLANs and IP Addresses" on page 42.)
2 In the Password field, type the enable password you configured on the
switch.
(See "Configuring an Enable Password" on page 38.)
Leave the User name field blank.
3 Click OK.
If your web browser has the Google toolbar installed, one of the toolbar's
options can cause some of the fields in Web Manager to be highlighted
in yellow. If you want to turn off the yellow highlighting, disable the
Automatically highlight fields that Autofill can fill option, which is
one of the toolbar's options.
You must specify the country in which you plan to operate the WX switch
and its MAP access points. MSS does not allow you to configure or
enable the MAP access point radios until you specify the country of
operation.
CAUTION: Setting the country code to the incorrect value can result in
the MAPs using the wrong radio channels and power levels for the
country. This can cause interference with other vital equipment.
S
ERVICE