Tabletop Installation; Powering On A Wx Switch - 3Com 3CRWX120695A Installation And Basic Configuration Manual

28 C 2: I
HAPTER NSTALLING AND

Tabletop Installation

Powering On a WX
Switch
C WX S
ONNECTING A
5 Lift the WX switch into position in the equipment rack.
WARNING: To prevent the WX switch from slipping, do not release the
switch until all the rack-mount screws are tight.
6 Insert the bottom rack-mount screws into the bracket flanges to secure
the WX switch to the equipment rack, then insert the top screws.
7 Go to "Powering On a WX Switch" on page 28.
1 On a clean work surface with no debris, carefully turn the WX switch
upside down.
2 Wipe the four placement locations for the rubber feet to clear away any
oil or dust. The location areas are marked by X's.
3 Attach the four rubber adhesive feet over the X's.
4 Turn the WX switch right-side up, and place the switch in position on the
table.
5 Go to "Powering On a WX Switch" on page 28.
The WX1200 and WX4400 require an AC power source.
WARNING: The WX switch relies on the building's installation for
overcurrent protection. Ensure that a fuse or circuit breaker no larger
than 120 VAC, 15 A U.S. (240 VAC, 10 A international) is used on the
phase conductors.
To power on a WX switch:
1 Make sure any power supply is fully seated in the WX switch.
2 For each power supply that you are using on the WX switch, attach a
power cord to an AC power source.
WITCH