Table of Contents
Advertisement
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist
audible alert (chime) after approximately
three seconds when an obstacle has been
detected, the vehicle is stationary, and the
brake pedal is applied.
Adjustable Chime Volume Settings
The Front and Rear chime volume settings
are programmable.
The settings may be programmed through
the Uconnect System. Refer to "Uconnect
Settings" in "Multimedia" in the Owner's
Manual for further information.
The chime volume settings include low,
medium, and high. The factory default
volume setting is medium.
ParkSense will retain its last known configu-
ration state through ignition cycles.
Enabling And Disabling ParkSense
Front ParkSense can be enabled and
disabled with the Front ParkSense switch.
Rear ParkSense can be enabled and disabled
with the Rear ParkSense switch.
158
When the Front or Rear ParkSense switch is
pushed to disable the system, the instrument
cluster display will show the "PARKSENSE
OFF"
message
for
approximately
seconds. Refer to "Instrument Cluster
Display" in "Getting To Know Your Instru-
ment Panel" in the Owner's Manual for
further information.
When the gear selector is moved to
REVERSE and the Front or Rear system is
disabled, the instrument cluster display will
show the "PARKSENSE OFF" message for as
long as the vehicle is in REVERSE.
The Front or Rear ParkSense switch LED will
be on when Front or Rear ParkSense is
disabled or requires service. The Front or
Rear ParkSense switch LED will be off when
the Front or Rear system is enabled. If the
Front or Rear ParkSense switch is pushed,
and the system requires service, the Front or
Rear ParkSense switch LED will blink
momentarily, and then the LED will be on.
Service The ParkSense Park Assist System
During vehicle start up, when the ParkSense
System has detected a faulted condition, the
instrument cluster will actuate a single
chime, once per ignition cycle, and it will
display the "PARKSENSE UNAVAILABLE
WIPE REAR SENSORS", "PARKSENSE
UNAVAILABLE WIPE FRONT SENSORS" or
"PARKSENSE
UNAVAILABLE
five
REQUIRED"
message.
selector is moved to REVERSE and the
system has detected a faulted condition, the
instrument cluster display will display a
"PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or "PARKSENSE UNAVAILABLE
SERVICE REQUIRED" message for as long
as the vehicle is in REVERSE. Under this
condition, ParkSense will not operate. Refer
to "Instrument Cluster Display" in "Getting
To Know Your Instrument Panel" in the
Owner's Manual for further information.
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" or "PARKSENSE UNAVAILABLE
WIPE FRONT SENSORS" appears in the
instrument cluster display make sure the
outer surface and the underside of the rear
fascia/bumper and/or front fascia/bumper is
clean and clear of snow, ice, mud, dirt or
other obstruction and then cycle the ignition.
If the message continues to appear, see an
authorized dealer.
If
the
"PARKSENSE
SERVICE REQUIRED" message appears in
the instrument cluster display, see an autho-
rized dealer.
SERVICE
When
the
gear
UNAVAILABLE
Advertisement
Table of Contents
