Parkview Rear Back Up Camera - Jeep GLADIATOR 2020 User Manual

Hide thumbs Also See for GLADIATOR 2020:
Table of Contents

Advertisement

WARNING! (Continued)
Before using ParkSense, it is strongly
recommended that the ball mount and
hitch ball assembly is disconnected from
the vehicle when the vehicle is not used
for towing. Failure to do so can result in
injury or damage to vehicles or obstacles
because the hitch ball will be much
closer to the obstacle than the rear fascia
when the loudspeaker sounds the contin-
uous tone. Also, the sensors could detect
the ball mount and hitch ball assembly,
depending on its size and shape, giving
a false indication that an obstacle is
behind the vehicle.
CAUTION!
ParkSense is only a parking aid and it is
unable to recognize every obstacle,
including small obstacles. Parking curbs
might be temporarily detected or not
detected at all. Obstacles located above
or below the sensors will not be detected
when they are in close proximity.
160
CAUTION! (Continued)
The vehicle must be driven slowly when
using ParkSense in order to be able to
stop in time when an obstacle is
detected. It is recommended that the
driver looks over his/her shoulder when
using ParkSense.
PARKVIEW REAR BACK UP
CAMERA
The ParkView Rear Back Up Camera allows
you to see an on-screen image of the rear
surroundings of your vehicle whenever the
gear selector is put into REVERSE. The
image will be displayed in the touchscreen
display along with a caution note to "check
entire surroundings" across the top of the
screen. After five seconds this note will
disappear. The ParkView camera is located
on the tailgate, above the vehicle license
plate.
(Continued)
Manual Activation Of The Rear View Camera
1. Go to the Controls screen by pressing the
"Controls" button located on the bottom
of the Uconnect display, and then press
"Backup Camera".
2. Press the "Backup Camera" button to
turn the Rear View Camera system on.
NOTE:
For vehicles equipped with the Uconnect
3 With 5-Inch Display, there is only one
option for manual activation of the Rear
View Camera. Press the "More" hard
button on the Uconnect system, and then
press "Backup Camera".
When the vehicle is shifted out of REVERSE
(with Camera delay turned off), the rear
Camera mode is exited and the previous
screen appears again.
When the vehicle is shifted out of REVERSE
(with Camera delay turned on), the rear Camera
image will be displayed for up to 10 seconds
unless the vehicle speed exceeds 8 mph
(13 km/h), the transmission is shifted into
PARK, the ignition is placed in the OFF posi-
tion, or the touchscreen button "X" to disable
display of the Rear View Camera image is
pressed.

Advertisement

Table of Contents
loading

Table of Contents