Table of Contents
Advertisement
9. Remove the hard top from the vehicle.
Install edge protectors and place the
hard top on a soft surface to prevent
damage.
NOTE:
To reinstall the hard top, follow the removal
instructions in reverse order.
For complete owner information, refer to your
Owner's Manual for further details.
CAUTION!
The front panel(s) must be positioned
properly to ensure sealing. Improper
installation can cause water to leak into
the vehicle's interior.
The hard top assembly must be posi-
tioned
properly
to
Improper installation can cause water to
leak into the vehicle's interior.
The hard top is not designed to carry any
additional loads such as roof racks,
spare
tires,
building,
camping supplies, and/or luggage, etc.
Also, it was not designed as a structural
member of the vehicle, and thus cannot
properly carry any additional loads other
than environmental (rain, snow, etc.).
44
Do not move your vehicle until the top
has been either fully attached to the
windshield frame and bodyside, or fully
removed.
The removal of the hard top requires four
adults located on each corner. Failure to
follow this caution could damage the
hard top.
Dual Top — If Equipped
If your vehicle is equipped with a Dual Top,
the soft top system will be provided in a
separate box located in the bed of the vehicle
for shipping purposes only.
For your convenience, a tool kit is provided
ensure
sealing.
with your vehicle located in the center
console. This kit includes the necessary tools
required for the operations described in the
following sections. All pieces fit into the
ratchet for easy use.
hunting,
or
(Continued)
CAUTION! (Continued)
Provided Tools
1 — #50 Torx Head Driver
2 — #40 Torx Head Driver
3 — 15 mm Socket
4 — Ratchet
NOTE:
The soft top and the hard top are to be
used independently.
Your vehicle warranty will not cover
damage resulting from both tops being
installed at the same time.
For complete owner information, refer to your
Owner's Manual for further details.
Advertisement
Table of Contents
