Table of Contents
Advertisement
3. Push
the
programmed
button to confirm that the garage door
opener motor operates. If the garage door
opener motor does not operate, repeat
the final steps for the rolling code proce-
dure.
Non-Rolling Code Garage Door Opener Final
Steps
1. Push and hold the programmed Home-
Link® button and observe the Home-
Link® indicator light. If the HomeLink®
indicator light stays on constantly,
programming is complete.
2. Push
the
programmed
button to confirm that the garage door
opener motor operates. If the garage door
opener motor does not operate, repeat
the steps from the beginning.
WARNING!
Your motorized door or gate will open
and close while you are programming the
universal transceiver. Do not program
the transceiver if people or pets are in
the path of the door or gate.
HomeLink®
WARNING! (Continued)
Do not run your vehicle in a closed
garage or confined area while program-
ming the transceiver. Exhaust gas from
your vehicle contains Carbon Monoxide
(CO) which is odorless and colorless.
Carbon Monoxide is poisonous when
inhaled and can cause you and others to
be severely injured or killed.
Programming HomeLink® To A
Miscellaneous Device
Refer to "Programming HomeLink® To A
HomeLink®
Garage Door Opener" for the procedure on
how to program HomeLink® to a miscella-
neous device, as it follows the same proce-
dure. Be sure to determine if the device has
a rolling code, or non-rolling code before
beginning the programming process.
NOTE:
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after
several seconds of transmission, which may
not be long enough for HomeLink® to pick
up the signal during programming. Similar to
this Canadian law, some U.S. gate operators
(Continued)
are designed to time-out in the same
manner. The procedure may need to be
preformed multiple times to successfully
pair the device to your HomeLink® buttons.
Reprogramming A Single HomeLink®
Button
To reprogram a single HomeLink® button
that has been previously trained, without
erasing all the channels, follow the proce-
dure below. Be sure to determine whether
the new device you want to program the
HomeLink® button to has a Rolling Code, or
Non-rolling Code.
1. Cycle the ignition to the ON/RUN posi-
tion, without starting the engine.
2. Push and hold the desired HomeLink®
button until the HomeLink® Indicator
light begins to flash after 20 seconds. Do
not release the button.
3. Without releasing the button, proceed with
Step 2 in "Programming HomeLink® To
A Garage Door Opener" and follow all
remaining steps.
49
Advertisement
Table of Contents
