Table of Contents
Advertisement
Power Inverter Switch
Exterior Truck Bed Power Inverter
NOTE:
400 W is the maximum for the inverter, not
each outlet. If two outlets are in use, 400 W
is shared amongst the devices plugged in.
The power inverter is designed with built-in
overload protection. If the power rating of
400 W is exceeded, the power inverter auto-
52
matically shuts down. Once the electrical
device has been removed from the outlet, the
inverter should automatically reset.
NOTE:
The Power Inverter will only turn on if the
ignition is in the ACC or ON/RUN position.
Due to built-in overload protection, the
Power Inverter will turn off if the power
rating is exceeded.
WARNING!
To avoid serious injury or death:
Do not insert any objects into the recep-
tacles.
Do not touch with wet hands.
Close the lid when not in use.
If this outlet is mishandled, it may cause
an electric shock and failure.
Auxiliary Switches — If Equipped
Four auxiliary switches are located in the
lower switch bank of the instrument panel
and can be used to power various electrical
devices.
The functionality of the auxiliary switches
can be changed via the Uconnect settings.
All switches can be configured for setting the
switch type operation to latching or momen-
tary, power source of either battery or igni-
tion, and ability to hold last state across key
cycles.
Auxiliary Switches
NOTE:
Holding last state conditions are met when
switch type is set to latching and power
source is set to ignition.
For more information, refer to "Uconnect
Settings" in "Multimedia" in the Owner's
Manual.
Advertisement
Table of Contents
