Installing The Steering Wheel - Toro Greensmaster eTriFlex 3370 Operator's Manual

Standard Seat (Model No. 04508)
1. Service decal
4
Installing the Steering
Wheel
Parts needed for this procedure:
1 Steering wheel
1 Cap
1 Washer
1 Locknut
Procedure
1. Apply anti-seize compound to the steering shaft.
2. Install the wheel to the steering shaft
1. Steering shaft
3. Connect the main-power connectors; refer to
Main-Power Connectors (page
Figure 5
(Figure
Figure 6
2. Steering wheel
20).
4. Insert the key and turn it to the O
5. Navigate to the traction information screen in the
InfoCenter; refer to
Display (page
6. Turn the steering wheel until the steering-wheel
angle (located at the bottom of the screen) reads
"0°". Do not rotate the wheel beyond the stops.
7. Turn the key to the O
the key.
8. Disconnect the main-power connectors.
9. Without turning the steering shaft, perform the
g277097
following steps:
A. Remove the wheel from the steering shaft.
B. Install the steering wheel in the position
shown in
1. Steering wheel
6).
10. Install the wheel to the steering shaft using the
washer and locknut
g288302
10
position.
N
Using the InfoCenter LCD
16).
position and remove
FF
Figure 7.
Figure 7
2. Steering shaft
(Figure 8).
g288301