Using The Infocenter To Adjust The Machine Settings - Toro Greensmaster eTriFlex 3370 Operator's Manual

1. Center cutting unit
2. Front left cutting unit
Using the InfoCenter
to Adjust the Machine
Settings
You can use the InfoCenter to adjust the following
machine settings:
•
Tap-off delay; refer to
(page 23).
•
Reel speed while mowing; refer to
Mowing Reel Speed (page
•
Reel speed while backlapping the cutting units;
refer to Adjusting the Backlap Reel Speed (page
24).
•
Clip control; refer to
Feature (page 24).
•
Height of cut (HOC); refer to
of Cut (HOC) (page
•
Number of cutting-unit blades; refer to
the Number of Cutting-Unit Blades (page
•
Maximum mowing speed; refer to
Maximum Mowing Speed (page
•
Maximum transport speed; refer to
Maximum Transport Speed (page
•
Maximum reverse speed; refer to
Maximum Reverse Speed (page
•
Slow and turn; refer to
Function (page 25).
Figure 27
3. Front right cutting unit
Adjusting the Tap-Off Delay
Adjusting the
23).
Setting the Clip-Control
Adjusting the Height
24).
Adjusting the
24).
Adjusting the
25).
Adjusting the
25).
Setting the Slow and Turn
•
Disabling an equipped 3-Wheel-Drive Kit; refer
to Disabling an Equipped 3-Wheel-Drive Kit (page
25).
•
Battery-reserve capacity; refer to
Battery-Reserve Capacity (page
Note:
Each setting is passcode-protected. You may
need to enter a passcode to edit the settings.
Adjusting the Tap-Off Delay
Navigate to the T
tap-off delay. The tap-off delay feature allows the
cutting units to turn off without raising. The delay
setting represents the maximum time for the lift/lower
joystick to remain in the rearward position to activate
this feature.
g289940
Refer to the following table for the delay time options
and their corresponding increment numbers:
Tap-Off Delay Options
Increment Number
1
2
3
4
5
6
7
8
9
10
Note:
The factory default setting is 1, which disables
this feature.
Adjusting the Mowing Reel Speed
Navigate to the R
speed while mowing. This setting can be adjusted
when the clip control setting is O
the Clip-Control Feature (page
Adjusting
24). Refer to the following table for the reel speed options
and their corresponding increment numbers:
Mowing Reel Speed Options
Increment Number
1
2
3
4
5
23
Setting the
25).
T option to adjust the
APOFF IME
Delay Time (Seconds)
Off
0.050
0.100
0.150
0.200
0.250
0.300
0.350
0.400
0.450
S option to adjust the reel
EEL PEED
; refer to
FF
24).
Reel Speed (RPM)
800
950
1100
1250
1400
Setting