Attachments/Accessories; Before Operation; Before Operation Safety; Identifying The Cutting Units - Toro Greensmaster eTriFlex 3370 Operator's Manual

Electrical Specifications Table
Voltage
Current
Amp Hours
IP Rating

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com or a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
48 V
DC ( )
213.6 AH
IP 65
Operation

Before Operation

Before Operation Safety

General Safety
•
Never allow children or untrained people to
operate or service the machine. Local regulations
may restrict the age of the operator. The owner
is responsible for training all operators and
mechanics.
•
Become familiar with the safe operation of the
equipment, operator controls, and safety signs.
•
Engage the parking brake, shut off the machine,
remove the key, and wait for all movement to stop
before you leave the operator's position. Allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
•
Know how to stop the machine and shut off the
machine quickly.
•
Check that operator-presence controls, safety
switches, and safety protective devices are
attached and functioning properly. Do not operate
the machine unless they are functioning properly.
•
Before mowing, always inspect the machine to
ensure that the cutting units are in good working
condition.
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
Identifying the Cutting
Units
The InfoCenter uses the numbers 1, 2, and 3 to
identify each cutting unit (e.g., CU1, CU2, and CU3
in the A menu).
BOUT
•
1 refers to the center cutting unit
•
2 refers to the front left cutting unit
•
3 refers to the front right cutting unit
22
(Figure 27)
(Figure 27)
(Figure 27)