Installing The Steering Wheel; Removing The Battery - Toro 08703 Operator's Manual

1

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
1 Foam collar
1 Washer
1 Locknut
1 Steering wheel cover
Procedure
1. Move the front wheel so that it points straight ahead.
2. Slide the foam collar, small end first, onto the steering
shaft (Figure 2).
1. Foam collar
2. Steering wheel
3. Washer
3. Slide the steering wheel onto the steering shaft (Figure
2).
4. Secure the steering wheel to the steering shaft with a
washer and locknut (Figure 2). Torque the locknut to
20–26 ft-lbs (27–35 N-m).
5. Install the steering wheel cover to the steering wheel
(Figure 2).
Figure 2
4. Nut
5. Steering wheel cover
2

Removing the Battery

No Parts Required
Procedure
Remove the (2) wing nuts and washers securing top battery
hold down to side battery hold downs (Figure 3). Remove top
battery hold and remove battery.
1. Battery
2. Positive (+) battery
terminal
11
Figure 3
3. Negative (-) battery
terminal
4. Top battery hold down