Monitoring The Battery-System Charge Level; Shutting Off The Machine; After Operation; After Operation Safety - Toro Greensmaster eTriFlex 3370 Operator's Manual

Cutting the Periphery and
Finishing the Job
1. Finish cutting the green by mowing the outer
periphery. Change the direction of cutting from
the previous mowing.
Refer to Understanding the
Radius-Dependent-Speed (RDS) System (page
24) to improve the after-cut appearance and
reduce triplex ring.
Note:
Always keep weather and turf conditions
in mind and be sure to change the direction of
mowing from the previous cutting.
2. When you finish mowing the outer periphery, tap
the lift/lower joystick rearward to stop the reels
(if the tap-off delay feature is engaged), then
drive off the green. When all the cutting units
are off the green, move the lift/lower joystick
rearward to raise the cutting units.
Note:
This step minimizes grass clumps left on
the green.
3. Replace the flag.
4. Empty the grass baskets of all clippings before
you transport the machine to the next green.
Note:
Heavy wet clippings cause strain on
the baskets, suspensions, and actuators. This
adds unnecessary weight to the machine, which
decreases energy efficiency.
Monitoring the
Battery-System Charge
Level
Refer to the main information screen in the InfoCenter
to determine the battery-system charge level; refer to
Using the InfoCenter LCD Display (page
Understanding the Low
Battery-Level Advisories
•
When the battery level reaches a low percentage,
an low-battery advisory appears on the InfoCenter.
When you are operating at this battery percentage,
finish cutting the current green, then transport the
machine to a designated battery-charging area
and charge the batteries; refer to
Lithium-Ion Batteries (page
•
If the battery level becomes too low (i.e., below
10%) while you are operating the machine, an
advisory appears on the InfoCenter. While you
are operating at this battery percentage, you can
only transport the machine at a slower speed; the
cutting units cannot be engaged. Transport your
16).
Charging the
35).
machine to a designated battery-charging area
and charge the batteries; refer to
Lithium-Ion Batteries (page

Shutting Off the Machine

1. Transport the machine to a level surface.
2. Move the function-control switch to the N
position.
3. Engage the parking brake.
4. Rotate the key to the O
the machine.
5. Remove the key.

After Operation

After Operation Safety

General Safety
•
Engage the parking brake, shut off the machine,
remove the key, and wait for all movement to stop
before you leave the operator's position. Allow
the machine to cool before adjusting, servicing,
cleaning, or storing it.
•
Clean grass and debris from the machine,
especially the cutting units and drives, to help
prevent fires.
•
Disconnect the main-power connectors while
storing or hauling the machine.
•
Disengage the drive to the attachment whenever
you are hauling or not using the machine.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Maintain and clean the seat belt(s) as necessary.
•
Do not store the machine where there is an open
flame, spark, or pilot light, such as on a water
heater or on other appliances.
Towing Safety
•
Tow only with a machine that has a hitch designed
for towing. Do not attach towed equipment except
at the hitch point.
•
Follow the manufacturer's recommendation for
weight limits for towed equipment and towing
on slopes. On slopes, the weight of the towed
equipment may cause loss of traction and loss of
control.
•
Never allow children or others in or on towed
equipment.
•
Travel slowly and allow extra distance to stop
when towing.
30
Charging the
35).
EUTRAL
position to shut off
FF