Controls - Toro Greensmaster eTriFlex 3370 Operator's Manual

Controls

Figure 16
1. Function-control switch
2. Lift/lower joystick
Key Switch
The key switch has 2 positions: O
17).
Use the key switch to turn on or shut off the machine;
refer to Turning On the Machine (page 27)
Shutting Off the Machine (page
Figure 17
1. O
N
Function-Control Switch
The function-control switch
traction selections plus a N
•
N position—neutral and backlapping
EUTRAL
•
M position—used for mowing operation
OW
•
T position—used for transport operation
RANSPORT
3. InfoCenter
4. Key switch
and O (Figure
N FF
and
30).
2. O
FF
(Figure 16) provides 2
position.
EUTRAL
You can shift from M
to M (not to N
OW
motion; no damage will result
You can move the switch from T
to N and the machine will come to a stop. If
EUTRAL
you try to switch from N
while the pedal is not in the N
advisory occurs.
Lift/Lower Joystick
The lift/lower joystick
the cutting units. The joystick can engage or
disengage the cutting-unit reels, depending on the
function-control-switch position:
•
Function-control switch in the N
position: The cutting units will raise or lower as
long as you move the joystick forward or backward,
but the reels will not engage unless the machine is
in Backlap Mode.
g267033
•
Function-control switch in the M
Move the joystick forward during your cutting
operation to lower the cutting units and start the
reels. Pull back on the joystick to stop the reels
and raise the cutting units.
To stop the reels without raising the cutting units,
pull back on the joystick momentarily and release
it. Moving the joystick forward again will start the
reels or pulling back again will lift the cutting units.
You must engage this feature in the InfoCenter;
refer to Adjusting the Tap-Off Delay (page
•
Function-control switch in the T
position: The cutting units can be raised, but the
reels will not engage. An advisory appears in the
InfoCenter if you attempt to lower the cutting units.
Traction Pedal
The traction pedal
make the machine move forward, to move it backward,
and to stop the machine. Press the top of the pedal to
move forward; press the bottom to move backward or
to assist in stopping when moving forward.
g292048
To stop the machine, allow the pedal to move to the
N position. Do not rest the heel of your foot on
EUTRAL
the traction pedal in the R
machine is moving forward
15
to T or T
OW RANSPORT
) while the machine is in
EUTRAL
RANSPORT
to M or T
EUTRAL OW
position, an
EUTRAL
(Figure 16) raises or lowers
EUTRAL
OW
RANSPORT
(Figure 18) has 3 functions: to
position while the
EVERSE
(Figure 19).
RANSPORT
or M
OW
RANSPORT
position:
23).