Understanding The Infocenter Dialog Messages - Toro Greensmaster eTriFlex 3370 Operator's Manual

Adjusting the Maximum Transport
Speed
Navigate to the M T
AX RANSPORT
maximum transport speed. You can adjust the speed
from 8.0 km/h (5.0 mph) to 16.0 km/h (10.0 mph) in
increments of 0.8 km/h (0.5 mph).
Note:
The factory default setting is 16.0 km/h (10.0
mph).
Adjusting the Maximum Reverse
Speed
Navigate to the M R
AX
maximum reverse speed. You can adjust the speed
from 3.2 km/h (2.0 mph) to 4.8 km/h (3.0 mph) in
increments of 0.8 km/h (0.5 mph).
Note:
The factory default setting is 4.0 km/h (2.5
mph).
Setting the Slow and Turn Function
Navigate to the S & T
LOW
and turn function. The slow and turn function slows
the machine speed while you turn the machine for
another cutting pass on a green.
Note:
The factory default setting is O
Disabling an Equipped
3-Wheel-Drive Kit
Navigate to the 3WD K
3-Wheel-Drive Kit.
If you choose to disable this option, the kit will be
enabled again if you cycle the key switch (i.e., turn
off, then turn on the machine) with an equipped
3-Wheel-Drive Kit.
Note:
When you install the 3-Wheel-Drive Kit, the kit
is automatically enabled.
Setting the Battery-Reserve
Capacity
Navigate to the B . R
ATT
amount of distance needed to transport the machine
to the shop. This allows you to have enough battery
power (when the battery level becomes too low) to
transport the machine to the shop for recharging; refer
to Monitoring the Battery-System Charge Level (page
30).
Note:
You can adjust the distance from 0.8 km (0.5
mi) to 8 km (5 mi) in 0.8 km (0.5 mi) increments.
option to adjust the
option to adjust the
EVERSE
option to set the slow
URN
.
FF
option to disable an equipped
IT
option to set the
ESERVE
Understanding the
InfoCenter Dialog
Messages
When the machine is being calibrated, dialog
messages appear in the InfoCenter. These messages
are intended to instruct you through the calibration
process.
Refer to the following table for a list of each dialog
message:
Dialog Messages
Message
InfoCenter Message Text
Number
1 Return pedal to neutral
4 Move pedal to max forward and hold
5 Max forward calibration passed
9
Max forward calibration failed. Voltage out of spec
13 Move pedal to max reverse and hold
14 Max reverse calibration passed
16 Max reverse calibration failed. Voltage out of spec
17 Calibration failed. Pedal position unknown
18
Return pedal to neutral. Continue?
100 Calibration is engaged
101 Calibration is complete
102 Cycle the key switch
110 Inhibit calibration. Component not responding
111 Inhibit calibration. Component not ready
112 Inhibit calibration. Fault active
113 Inhibit calibration. Not in seat
114 Inhibit calibration. Not in neutral
115 Inhibit calibration. In neutral
116 Inhibit calibration. Parking brake is engaged
300 Return pedal to neutral
301 Center steering wheel. Continue?
302 Manually center rear wheel. Continue?
303 Steer rear wheel max left. Continue?
304 Steer rear wheel max right. Continue?
305 Rear wheel center out of range
306 Rear wheel angle out of range
400 Caution: Machine must be on jack stands.
Continue?
401 Inhibit calibration. Contactor open
402 Inhibit calibration. Pedal in Neutral
403 Return pedal to neutral
25