Greasing The Mower Deck And Belt Idlers; Greasing The Caster Pivots - Toro Z Master Professional 7000 Series Operator's Manual

Greasing the Mower Deck
and Belt Idlers
Service Interval: Every 25 hours—Grease the mower
deck and spindles.
Grease Type: No. 2 lithium or molybdenum grease
Important:
Make sure that the mower-deck
spindles are full of grease weekly.
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the belt covers.
4. Grease the idler arm on the mower deck
40).
5. Grease the fittings on the push arms
Figure 40
52-inch and 60-inch Mower Decks
6. Grease the PTO-drive belt idler arm
7. Grease the pump belt idler arm
(Figure
(Figure 40).

Greasing the Caster Pivots

Service Interval: Every 400 hours/Yearly (whichever
1.
2.
3.
g187362
4.
5.
(Figure 41).
6.
(Figure 41).
7.
39
Figure 41
comes first) (more often in dirty or
dusty conditions).
Yearly—Repack the caster-wheel bearings
(more often in dirty or dusty conditions).
Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Remove the dust cap and adjust the caster
pivots and keep the dust cap off until greasing is
done; refer to Greasing the Caster-Wheel Hubs
(page 40).
Remove the hex plug.
Thread a grease fitting into the hole.
Pump grease into the fitting until it oozes out
around the top bearing.
Remove the grease fitting from the hole. Install
the hex plug and cap.
g007170