Lubrication; Greasing The Machine - Toro Z Master Professional 7000 Series Operator's Manual

Maintenance Service
Interval
Every 400 hours
Every 500 hours
Monthly
Yearly
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Shut off the engine and remove the key from the switch before you perform any maintenance.

Lubrication

Greasing the Machine

Grease the machine more often in dirty or dusty
conditions. Refer to Figure 39
grease fittings.
Grease Type: No. 2 lithium or molybdenum grease
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
Scrape any paint off the front of the
fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
Maintenance Procedure
• Grease the caster pivots (more often in dirty or dusty conditions).
• Replace the fuel filter (more often in dirty or dusty conditions).
• Check the wheel lug-nut torque.
• Check the wheel hub castle nut.
• Adjust the caster-pivot bearing.
• Adjust the electric clutch.
• Change the hydraulic filter and hydraulic fluid when using Toro® HYPR-OIL™ 500
hydraulic fluid.
• Check the battery charge.
• Repack the caster-wheel bearings (more often in dirty or dusty conditions).
• Greasing the caster-wheel hubs.
• Change the gearbox oil.
• Change the engine coolant.
for the location of
38
Figure 39
decal140-4362