Transporting The Machine - Toro Z Master Professional 7000 Series Operator's Manual

Changing to Machine Operation
Rotate the bypass valves clockwise 1 turn to operate
machine (Figure 35).
Note:
Do not over-tighten the bypass valves.
Important:
The machine does not drive unless
bypass valves are turned in.
Figure 35
1. Side console controls
2. Bypass valve
g010371
3. Hydraulic pumps

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
Selecting a Trailer
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure that the length of the ramp is at
least 4 times as long as the height of the
trailer or truck bed to the ground. This
ensures that the ramp angle does not
exceed 15 degrees on flat ground.
34
(Figure 36).