Setting The Hydraulic Pump Neutral Position - Toro Z Master Professional 7000 Series Operator's Manual

Setting the Hydraulic Pump
Neutral Position
Note:
Adjust the handle neutral first. That needs
to be correct before you can make the following
adjustment.
This adjustment must be made with drive wheels
turning.
DANGER
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
• Use a jack stand when supporting the
machine.
• Do not use hydraulic jacks.
WARNING
The engine must be running so that you can
adjust the motion control. Any contact with
moving parts or hot surfaces may cause
personal injury.
Keep your hands, feet, face, clothing and
other body parts away from rotating parts,
muffler and other hot surfaces.
1. Raise the frame and block up the machine so
that the drive wheels can rotate freely.
2. Disconnect the electrical connector from the seat
safety switch. Temporarily install a jumper wire
across terminals in the wire-harness connector.
3. Unlatch the seat and slide seat forward.
4. Disconnect the seat rod and tilt the seat fully
forward.
Setting the Right Hydraulic Pump
Neutral Position
1. Start the engine, open the throttle 1/2 way and
disengage parking brake; refer to
the Parking Brake (page
Note:
The motion-control lever must be in
neutral while making any adjustments.
2. Adjust the pump rod length by rotating the knob,
in the appropriate direction, until the wheel is still
or slightly creeping in reverse
3. Move the motion-control lever forward and
reverse, then back to neutral.
Disengaging
25).
(Figure 87).
Note:
The wheel must stop turning or slightly
creep in reverse.
4. Open the throttle to
Note:
Make sure that the wheel remains
stopped or slightly creeps in reverse; adjust if
necessary.
1. Tracking knob
2. Hydraulic tank
3. Hydraulic pumps
64
.
FAST
Figure 87
4. Turn this way to track right
5. Turn this way to track left
g001070