Replacing The Pump-Drive Belt; Replacing And Tensioning The Alternator Belt - Toro Z Master Professional 7000 Series Operator's Manual

8. Install the rubber clutch stop.
9. Install the spring to the idler arm
1. Gearbox
2. Spring
3. Spring-loaded idler pulley
Replacing the Pump-Drive
Belt
Service Interval: Every 50 hours—Check the
pump-drive belt.
Note:
Remove the PTO-drive belt first if the
pump-drive belt needs to be replaced.
1. Tilt the seat forward and remove the front engine
panel.
2. Remove the PTO-drive belt.
3. Remove the spring from the idler arm
77).
4. Install the new belt around the engine and
hydraulic pump pulley
5. Install the PTO-drive belt.
6. Install the spring to the idler arm
(Figure
Figure 76
4. Clutch
5. Rubber clutch stop
6. PTO-drive belt
(Figure
(Figure 77).
(Figure
76).
1. Clutch
2. Pump-drive belt
g007176
Replacing and Tensioning
the Alternator Belt
Replacing the Alternator Belt
Service Interval: Every 50 hours—Check the
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the 4 bolts holding the oil cooler shield
to the rear frame
4. Remove the 3 bolts holding the engine straps to
the side of the machine
77).
59
Figure 77
3. Spring
4. Spring-loaded idler pulley
alternator belt.
(Figure 78).
(Figure 78).
g007177