Greasing The Mower Deck And Belt Idlers - Toro Z Master Professional 7000 Series Operator's Manual

Greasing the Mower Deck and
Belt Idlers
Service Interval: Every 25 hours—Grease the mower deck
and spindles.
Every 25 hours—Grease the pump belt idler arm.
Every 25 hours—Grease the drive belt idler arm.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Important: Make sure cutting unit spindles are full of
grease weekly.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the belt covers and the bolts attached to them.
4. Grease the three spindle bearings until grease comes
out (Figure 30).
5. Grease the fittings on the push arms (Figure 30).
6. Grease the PTO drive belt idler arm (Figure 31).
7. Grease the pump belt idler arm (Figure 31).
G012504
Figure 30
30
Figure 31